Three cylinder smooth operation 10Mpa cement grout pump:

High pressure Cement Grout Pump (Model BW150-10) cement slurry grouting pump is a three-cylinder reciprocating single-acting piston pump driven by V-belt. Cement Grout Pump has the characteristics of smooth operation, no noise, absorbable vibration and mitigation of impact. When overloaded, there is relative sliding between the belt and the pulley without damaging other parts, and it plays a protective role. Cement Grout Pump can change two different working pressures and flow rates. Cement Grout Pump is a simplified improvement of the traditional BW150 cement slurry grouting pump.

Three cylinder smooth operation 10Mpa cement grout pump main technical parameters:

Three cylinder smooth operation 10Mpa cement grout pump structure:

It is mainly composed of pump body, pump frame, air chamber, shock-resistant pressure gauge, motor, V-belt and pulley cover.

The installation foundation of grouting pump should be smooth and not inclined.
The pump is fixed on the foundation with the foot screw to prevent the vibration of the pump during operation.
Preparations before pumping:
After the pump has been stopped or reinstalled for a long time, the following preparations must be made before starting.
1. Check whether there is enough lubricating oil in each part.
2. Check whether the suction pipe of the filter is unblocked.
3. Check whether there is obstruction in the movement of each part.
4. Check the accuracy and reliability of the transmission mechanism.
5. Check the looseness of fasteners, especially the screw tightening of rubber piston locking nut, cross head and piston rod connection thread.
6. Check the suction height of the pump. The maximum suction height of the pump should not exceed 2.5 meters in areas below 1000 meters above sea level. In areas above 1000 meters above sea level, the suction height of the pump should be reduced according to the local atmospheric pressure reduction.
7.Check the position of the filter immersed in the mud tank. Generally, the mud level should be below 0.3-0.5 meters, and the filter should be no less than 0.5 meters away from the bottom of the mud tank.

Three cylinder smooth operation 10Mpa cement grout pump maintenance:

1. Check the sealing condition of each sealing part regularly.
2. Warning: If oil or slurry leakage is found, repair or replace the seal immediately, so as not to cause more unnecessary losses.
3. Check the lubrication of each moving part regularly, and always keep enough lubricating oil in each lubricating part.
4. Check the looseness of fasteners frequently.
5. Attention should be paid to the abnormal noise of the pump when it is working. If abnormal noise occurs, the pump should be stopped to check and eliminate.
6. BWl50/10 grouting pump can be decomposed and transported according to three parts: pump body, power machine and frame. When repairing, the pump body and motor can be all disassembled.

Henan Tytion Machinery Co., Ltd is a joint venture enterprise which is mainly offer construction support machine, such as: cement grout pump; high pressure grouting pump; mortar grout pump; hydraulic grouting pump (for two liquid grouting); dry mix shotcrete machine; wet shotcrete machine; concrete pump; tunnel machine; and environment friendly equipment: scrap shear machine and hydraulic baling machine.